PREVENTION At work with a cable it is necessary to consider that the cable very fragile and it cannot be bent. A cable which was exposed to a peregibaniye, it is necessary to replace.

Removal and installation of a cable of an accelerator carry out in the following order:

remove the bottom furnish of the dashboard under a steering column;

slightly press a pedal of an accelerator and disconnect an accelerator cable from an accelerator pedal;

on a partition of a motor compartment unscrew fastening of a sealing ring of a cable of an accelerator;

in a motor compartment remove a bracket and disconnect the end of a cable of an accelerator from the lever of the fuel pump of a high pressure;

shift condensing rubber ring and take a cover of a cable of an accelerator from an arm;

release an accelerator cable from brackets of fastening and take it in a motor compartment;

installation of a cable of an accelerator is made in sequence, return to removal.