Removal of a front bumper make in the following order:

– unscrew three screws of fastening of the bottom lattice of an air inlet;

– disconnect ledges of fastening and remove a lattice, having lowered it down;

Fig. 16.6. Details of a front bumper: 1–bumper basis; 2–arm; 3–bolt; 4–sealing washer; 5–the directing; 6–consolidation; 7–strut pin; 8–bumper; 9–spoiler

– disconnect and remove pins 7 (fig. 16.6) of the strut, fixing a bumper 8 to the loose leaf of a wheel arch;

– disconnect contact sockets of fog lights;

– unscrew bolts of fastening of a bumper, without turning on a bolt of fastening of the engine to a body;

– having shifted forward, remove a bumper.

Installation carry out to sequences, return to removal.

Tighten bolts of fastening of a bumper the demanded moment.

Check work of washers of headlights.

Removal of a rear bumper make in the following order:

– from below unscrew five screws of fastening of a bumper to a body;

– remove a covering of a luggage compartment then unscrew four bolts of fastening;

Fig. 16.7. Details of a rear bumper: 1, 2 – bolts; 3–arm; 4–bumper basis; 5–sealing washer; 6–the directing; 7–bumper; 8–screw; 9–an arm (for a body the versatile person)

– remove a bumper 7 (fig. 16.7) .

Installation carry out to sequences, return to removal.

Tighten bolts of fastening of a bumper the demanded moment.