VW Passat repair

+ 1. Ekspluatatsiiya of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Power supply system
+ 6. Ignition system
+ 7. Coupling
+ 8. Transmission
+ 9. Drive of forward wheels
- 10. Suspension brackets
   + 10.1. Forward suspension bracket
   - 10.2. Back suspension bracket
      10.2.1. Technical characteristics
      10.2.2. General data
      10.2.3. Replacement of the bearing of a nave of a back wheel
      10.2.4. Pin of a back wheel
      10.2.5. Rack of a back suspension bracket
      10.2.6. Beam of a back suspension bracket
      10.2.7. Back suspension bracket of the all-wheel drive car (Syncro)
      10.2.9. System of self-alignment of a suspension bracket
+ 11. Steering
+ 12. Brake system
+ 13. Wheels and tires
+ 14. Systems of heating, ventilation and conditioning
+ 15. Electric equipment
+ 16. Body
+ 17. Electric circuits


Repair B3-B4/Passat B3-B4 Volkswagen Passat>> Suspension brackets>> Back suspension bracket>> Pin of a back wheel
Removal of a pin make in the following order:
– fix forward wheels;
– will hang out and fix on basic racks a back part of the car;
– remove brake a drum/nave or a disk/nave;
– on cars with brakes of drum-type type remove the brake mechanism of a back wheel;
– disconnect a brake tube from the working brake cylinder;
– disconnect a cable of the hand brake;
– unscrew bolts of fastening and remove a brake board and a pin.
Installation is carried out to sequences of return to removal.

Fig. 10.22. Cover ring installation

On cars with disk back brakes check and if necessary fix a cover ring the special VW-519 adaptation or a tubular opravka of the corresponding diameter (fig. 10.22) .
Remove air from brake system and adjust the hand brake.