Removal and installation of a quencher of krutilny fluctuations carry out in the following order:

– will hang out a forward part of the car and fix it basic racks;

– clear a quencher of krutilny fluctuations then turn it so that to provide access to the cylindrical pin fastening together two half of a quencher;

Fig. 9.21. An arrangement of a cylindrical pin for connection of two half of a quencher of krutilny fluctuations

– a drift with a thin sting, beat out a cylindrical pin from a quencher and remove a quencher from a power shaft (fig. 9.21) .

Installation make in sequence, return to removal, thus use a new cylindrical pin. If it is necessary, replace a sticky tape under a quencher.

Monolithic quencher  since August, 1989

Removal and installation of a quencher of krutilny fluctuations carry out in the following order:

– remove the corresponding power shaft. Remove from a shaft the internal hinge.

– displace on a power shaft a quencher of krutilny fluctuations.

Fig. 9.22. An arrangement of a quencher of krutilny fluctuations (And) on driving to a shaft: and = 264,5 mm for the left shaft and 521 mm – for the right shaft

Installation make in sequence, return to removal. Establish a quencher on a shaft so that to sustain distance of installation of a quencher (fig. 9.22) . Establish the internal hinge and a power shaft.