Removal of an intermediate shaft is carried out in the following sequence:

– remove the engine from the car;

– remove the distributor ignitions (SOHC engines);

– remove a belt of a drive of GRM (see подразд. 3.1.4);

Fig. 3.2. Drive of the gas-distributing mechanism (GRM): 1–top cover of GRM; 2–bolts; 3–top protective plate; 4–belt of a drive of a camshaft; 5–tension roller; 6–nut of fastening of a tension roller; 7–protective plate; 8–belt of a drive of the generator and water pump; 9–pulley of a cranked shaft; 10-bottom cover of a belt of a drive of a camshaft; 11-gear pulley of a cranked shaft; 12-bolt of fastening of a gear pulley of a cranked shaft; 13-gear pulley of an intermediate shaft

– remove a protective plate 7 (see fig. 3.2 );

– unscrew bolts of fastening and remove an arm of fastening of the generator;

– unscrew a bolt of fastening of a gear pulley of an intermediate shaft, holding a pulley from a provorachivaniye the special adaptation;

– remove a gear pulley of an intermediate shaft and a pulley shponka;

Fig. 3.27. Block of cylinders, cranked and intermediate shaft: 1–bolts of fastening of a cover of the radical bearing of a cranked shaft; 2–cover of the radical bearing of a cranked shaft; 3–loose leaf of the radical bearing of a cranked shaft; 4, 6 – persistent half rings; 5–loose leaf of the central (persistent) radical bearing of a cranked shaft; 7–cranked shaft; 8–bolt of fastening of a cover of an intermediate shaft; 9–epiploon of an intermediate shaft; 10-cover of an intermediate shaft; 11-sealing ring of a cover of an intermediate shaft; 12-intermediate shaft; 13-forward epiploon of a cranked shaft; 14-bolts of fastening of a forward cover of a cranked shaft; 15-forward cover of a cranked shaft; 16-laying of a forward cover of a cranked shaft; 17-block of cylinders

– unscrew bolts of fastening 8 (fig. 3.27) and uncover 10 intermediate shaft 12 with a sealing ring 11;

– remove an epiploon 9 intermediate shaft 12;

– remove an intermediate shaft 12;

– clear an intermediate shaft and examine it. In the presence of damages it is necessary to replace it.

Installation of an intermediate shaft is carried out in the following sequence:

– grease necks of an intermediate shaft 12 and accurately insert a shaft into the block of 17 cylinders;

– grease working edges of a new epiploon 9 intermediate shaft and insert an epiploon into a cover 10 intermediate shaft in careful blows of a hammer on an opravka;

– establish a new sealing ring 11 on a cover 10;

– establish a cover 10 on the block of cylinders and tighten it bolts 8;

– check axial люфт an intermediate shaft by means of the indicator of hour type.

Other operations execute in sequence, return to removal.