PREVENTION The fuel level sensor is necessary for removing in well aired room.

Removal and installation of the fuel level sensor carry out in the following order:

– disconnect a wire from the negative plug of the storage battery;

– remove a floor covering in a luggage carrier;

Fig. 5.12. A fuel tank and the fuel pump of cars with the SOHC engine: 1–cover of a bulk mouth; 2–lock ring; 3–rubber sealant; 4–connection of the tire of grounding, 5 – a broad tank; 6–union of supply of fuel; 7–flange nut; 8–union of return of fuel; 9–cover; 10-consolidation; 11-hose; 12-consolidation; 13-washer; 14-rubber dampers, 15 – the fuel pump; 16-casing of the fuel pump; 17-lock ring; 18-the fuel level sensor, 19 – consolidation; 20-bolt; 21-fastening tire; 22-ventilation valve; 23-tube сапуна (Versatile person); 24-tube сапуна; 25-bolt; 26-consolidation; 27-a hose to the coal filter; 28-valve

– disconnect the electric tip from a cover 9 (see fig. 5.12 ) a fuel tank;

– note an arrangement of fuel hoses on unions of a cover and remove them from unions;

Fig. 5.16. Fuel level sensor: 1–flange nut; 2–cover; 3–connector; 4–fuel pump; 5–plugs; 6–mesh filter; 7–sealing ring; 8–float lever

– unscrew a big flange nut 1 (see fig. 5.16 );

– take the sensor from a tank, thus do not bend the lever of a float 8;

– if in a tank the fuel pump is established, the sensor is taken together with submitting fuel pump.

Installation carry out to sequences, return to removal.